2/10/2023 0 Comments Best laser free engraving softwarePatterns in the wood will have different burn characteristics. Just expect that and learn to compensate when needed. So, what worked on this bit may be a little off on the next bit. Even the same type can vary from section to section, sheet to sheet, etc. I tend to tape thin plywood (1-6mm) around the edges if I have a warped piece, convex side down, which is often with cheap materials.ĭifferent types of wood can have very different characteristics when it comes to engraving/cutting. If it’s warped, then you need to work out a way to make it flat. For the impatient, see the Quick Version down at the bottom. This lesson is to help you put in less garbage and get something great out. As the saying goes, garbage in, garbage out. But it’s very unlikely that it will be a great result. Sure, anyone can toss an image into their burning software of choice and get a result, maybe even a good result. Time for a quick(ish) lesson in photo engraving. Get yourself some waste material, the cheap stuff, and see what happens.” - Me You * will* have failures, and that’s both ok and normal. “This is 5% doing, and 95% mucking around and finding out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |